Adjusting bevel angles

The bevel angle can be set between 47° (left-hand side) and 47° (right-hand side).

For quick and precise setting of frequently used bevel angles, fixed positions have been provided for the angles 0°, 33.9° and 22.5°.

  • Pull the right-hand adjustable fence (18) all the way out or remove it completely.
  • Release the clamping wheel (38).
  • Tilt the tool arm on the handle (4) slightly to the left from the 0° position and push the adjusting lever (20) to the left.
  • Use the handle (4) to swivel the tool arm to the right until the angle indicator (50) shows the required bevel angle on the scale (51).
  • Hold the tool arm in this position and retighten the clamping wheel (38).

  • Pull the left-hand adjustable fence (18) all the way out or remove it completely.
  • Release the clamping wheel (38).
  • Use the handle (4) to swivel the tool arm to the left until the angle indicator (52) shows the required bevel angle on the scale (51).
  • Hold the tool arm in this position and retighten the clamping wheel (38).

  • Ensure that a bevel angle of < 45° (left or right) is set.
    Only then can you press the locking button (53).
  • Push the locking button (53) fully in.
    This enables you to use the complete bevel angle range up to 47° (left and right).

  • Pull the adjustable fence (18) all the way out or remove it completely.
  • Release the clamping wheel (38).

Standard bevel angle 0°:

  • Swivel the tool arm slightly to the left to the 0° position and then to the right until you feel it click into place in the 0° position.
  • Retighten the clamping wheel (38).

Standard bevel angle 33.9° and 22.5°:

  • Release the locking lever (21) upwards.
  • Swivel the tool arm left or right until the angle indicator (52)/(50) shows the required bevel angle.
    The tool arm must engage securely in place.
  • Retighten the clamping wheel (38).