Product features
The numbering of the product features refers to the diagram of the power tool on the graphics page.
(1) | Right handle (insulated gripping surface) |
(2) | Spindle lock button |
(3) | Chip protection |
(4) | Wing bolt for parallel guide rods (2x) |
(5) | Base plate |
(6) | Guide plate |
(7) | Holder for parallel guide rods |
(8) | Step buffer |
(9) | Wing bolt for depth stop adjustment |
(10) | Slide with index mark |
(11) | Left handle (insulated gripping surface) |
(12) | Clamping lever for locking the routing depth |
(13) | Scale for setting the routing depth |
(14) | Depth stop |
(15) | Scale for fine adjustment of the routing depth |
(16) | Adjustment knob for fine adjustment of depth-of-cut (plunge base) |
(17) | Speed preselection thumbwheel |
(18) | Router bitA) |
(19) | On/off switch |
(20) | Lock-on button and unlock key for on/off switch |
(21) | Open-ended spanner (17 mm, 24 mm) |
(22) | Cap nut with collet |
(23) | Dust extraction adapter (plunge base) |
(24) | Knurled screw for dust extraction adapter (2x) |
(25) | Extraction hose (dia. 35 mm)A) |
(26) | Dust extraction adapter (non-plunge base)A) |
(27) | Intermediate ring for extraction adapterA) |
(28) | Parallel guide |
(29) | Wing bolt for parallel guide coarse adjustment |
(30) | Guide rod for parallel guide |
(31) | Knob for parallel guide fine adjustment |
(32) | Centring pin |
(33) | Adjustable fence for parallel guide |
(34) | SDS guide-bushing adapter |
(35) | Fastening screw for guide-bushing adapter (2x) |
(36) | Release lever for guide-bushing adapter |
(37) | Guide bushing |
(38) | Plunge base |
(39) | Fastening screw for guide plate |
(40) | Centring pinA) |
(41) | Extraction hood for edge routing |
(42) | Guide wheelA) |
- A)
This accessory is not part of the standard scope of delivery.