Start-up

Pay attention to the mains voltage. The voltage of the power source must match the voltage specified on the rating plate of the power tool.

To start the power tool, first press the lock-off button (5). Then press the on/off switch (33) all the way in and keep it pressed.

Note: For safety reasons, the on/off switch (33) cannot be locked; it must remain pressed during the entire operation.

To switch off, release the on/off switch (33).

The electronic starting current limitation (Soft Start) restricts the power consumption when the power tool is switched on and enables operation with a 16 A fuse.

Note: If the power tool runs at full speed immediately after being switched on, this means that the starting current limitation has failed. The power tool must be sent to the after-sales service without delay.

Start-up

Switching on (see figure M)

Switching off

Starting current limitation (Soft Start)