Start-up

Setting the cutting depth

Note: The power tool is optimised for cutting depths of up to 1 mm.

The cutting depth can be continuously adjusted from 0–1.0 mm using the knob (1). For cutting depths greater than 1 mm, the button (2) must be pressed:

Material

Planing width in mm

Cutting depth in mm

0–1.0

0–2.0

Softwood

< 30

●

●

30−40

●

−

Hardwood

< 20

●

●

20−30

●

−

Softwood (wet)

0−40

●

−

Plywood

< 20

●

●

20−30

●

−

Phenolic resin-coated plywood

< 15

●

●

15−30

●

−

MDF sheets

< 20

●

●

20−30

●

−

Veneers

1

●

●

Hardwood veneers

3−5

●

●

Two-part filler

3−5

●

●

Cardboard

2

●

●

Switching on/off

To start the power tool, first press the lock-off switch (3), then press and hold the on/off switch (4).

To switch off the power tool, release the on/off switch (4).

Note: For safety reasons, the on/off switch (4) cannot be locked; it must remain pressed during the entire operation.