Operation in the L-BOXX

The cover of the L-BOXX must remain fully open during charging. The safety latch must be attached to the lid of the L-BOXX. The charger cable must be fed through the cable outlet in the L-BOXX.

The L-BOXX is not included with the product as standard.

Fitting the Charger

To use the charger in the L-BOXX, perform the following steps:

Open the lid of the L-BOXX completely until the safety latch (11) clicks into place. The safety latch (11) prevents the lid of the L-BOXX from being closed unintentionally.

Guide the charger cable through the cable outlet (12) in the L-BOXX and insert the mains plug in the socket.

Preparing for Transport in the L-BOXX

Perform the following steps after operation and before transporting in the L-BOXX:

Pull the mains plug of the cable out of the plug socket.

Remove the charger cable from the cable outlet (12) and stow it in the L-BOXX so that it cannot be pinched.

To close the L-BOXX, lift the safety latch (11) slightly. This allows the locking mechanism to be released by the safety latch.

Close the lid of the L-BOXX completely.