Dust Reduction

Do not carry out drilling without taking dust-reducing measures. Depending on the intended application, the power tool can be combined with a dust-reducing accessory together with a dust extractor.
Always use suitable breathing protection. The regulations on the materials being machined that apply in the country of use must be observed.

Avoid dust accumulation at the workplace. Dust can easily ignite.

Requirements for the Dust Extractor
Recommended hose nominal diameter	mm	35
Required vacuum pressure^A)	mbar hPa	≥ 230 ≥ 230
Required flow rate^A)	l/s m³/h	≥ 36 ≥ 129.6
Recommended filter efficiency		Dust class M^B)

A): Power value at the power tool’s dust extractor connection

B): According to IEC/EN 60335-2-69

Refer to the dust extractor’s instructions. If there is reduced suction power, stop working and eliminate the cause.