Preparing the Saw Stand
Preparing holder sets (see figures C1–C4)
- Screw the locking knob (8) into the corresponding hole of the holder set (6).
- Measure the distance x between the assembly holes on your power tool.
- Position the holder sets (6) in the centre of the saw stand and at the appropriate distance x from each other.
- Tighten the locking knobs (8). This allows the holder sets to be firmly positioned on the saw stand.
Fastening the Power Tool on the Holder Sets (see figure D)
- Bring the power tool into the transport position. Information about the transport position can be found in the operating instructions for the corresponding power tool.
- Position the movable nuts (16) in the holder sets so that they match the assembly holes on the power tool.
Note: The cross slot in the holder set (6) also allows power tools with offset mounting holes to be secured. - Screw the holder set (6) and power tool together using the hexagon screws (11), lock washers (13) and washers (12) from the fastening set.