Cable threading

• Select the required working mode.
• Set the feed direction by pressing the switch (6) all the way to the left (see figure D).
• Turn the nozzle (3) to a suitable working angle, ensuring that the nozzle holder ring is firmly seated at the end of the conduit (see figure (19) G).
• Press the on/off switch (7). Hold the power tool firmly and apply adequate pressure to counteract unexpected resistance during feeding.
• Release the on/off switch (7) as soon as the tape (2) has been fed completely through the conduit.
• Securely attach the cable to the tape (2) (see figure H). It is recommended to wrap the connection with insulating tape to prevent it from coming loose when the cable is being threaded.
• Before retracting in the cable, ensure that the other end of the cable is properly attached and free of obstacles.
• Set the retract direction by pressing the switch (6) all the way to the right (see figure E).
• Press and hold the on/off switch (7) until the tape (2) stops automatically. Then it is fully retracted to its starting position.

Note: Never apply lubricant to the tape (2) during operation, as this may reduce the pulling force and impair the function of the power tool.