Setting the tape direction (see figures D-F)

The direction of travel of the tape (2) can be changed using the switch (6). However, this is not possible while the on/off switch (7) is being pressed. Only operate the switch (6) when the power tool is switched off.

• Feeding: To feed the tape (2) into the conduit, press the switch (6) all the way to the left (see figure D).
• Retracting: To retract the tape (2) from the conduit, press the switch (6) all the way to the right (see figure E).
• Note: If the switch (6) is in the centre position, the on/off switch (7) is blocked (see figure F). Always centre the switch (6) when the power tool is not in operation to prevent accidental triggering.