Starting Operation

  • To switch on the power tool, press the on/off button (21) for at least 1 second.
    The on/off indicator (20) lights up.
    GNH18V-64-3M: If single actuation is activated, the (26) indicator lights up.
  • To switch off the power tool, press the on/off button (21) for at least 1 second.

  • Firmly position the outlet (15) or the rubber workpiece protector (1) on the workpiece until the discharge lock-off (2) is pressed down completely.
    The worklight (8) switches on.
  • Afterwards, briefly press the trigger (4) and release it again.
    This discharges a nail.
  • For another driving procedure, completely lift the power tool from the workpiece and position it firmly at the next required location.
    Alternatively, you can press and hold the discharge lock-off (2) and press the trigger (4) to discharge another nail.

(GNH18V-64-3M)

  • Activate the contact actuation by briefly pressing the mode button (25).
    The contact actuation indicator (27) lights up.
  • Press and hold the trigger (4).
    The worklight switches on.
  • Firmly position the outlet (15) or the rubber workpiece protector (1) on the workpiece until the discharge lock-off (2) is pressed down completely.
    This discharges a nail.
  • For another discharging procedure, keep the trigger (4) pressed and completely lift the power tool from the workpiece. Replace it firmly in the next required position.
  • Switch to single actuation by pressing the mode button (25) again.
    The single actuation indicator (26) lights up.