Assembly of the Fan

Assembly on Rods Using Rod Holders (see figure G)

The fan can be attached to poles (max. diameter 20 mm) using the two pole mounts (13).

Position the pole mounts (13) over the poles and slide the fan onto the poles.

Mounting on a Tripod using the Tripod Thread (see figure H)

Notes on using the tripod

Only use the mounted fan in an upright position on the tripod.
Adjust the tripod legs so that the tripod is stable and the centre column is plumb.
Use a tripod with a load capacity of more than 3 kg.

Mount the fan on the tripod

Position the fan’s tripod mount (14) over the tripod’s fastening screw (5/8") and place the fan onto the fastening screw.

Note: Make sure that the fan’s tripod mount (14) is fully seated on the fastening screw.

Turn the fan clockwise as far as it will go to attach the fan to the tripod.