Work preparation

  • Position the power tool on the workpiece and align it.
  • Press the I button of the magnet on/off switch (1) and check that the power tool adheres to the surface of the workpiece.
  • Use the safety strap (28) to secure the power tool if necessary.

  • Whenever you are working overhead or on diagonal or vertical surfaces, secure the power tool with the supplied safety strap to prevent it from falling over.
  • Check that the safety strap is working properly before you use it. Never use a safety strap that is damaged; instead, replace it immediately.
  • Attach the safety strap (28) to the power tool so that it is as free of play as possible.
  • Push the safety strap through the holder (7) and place it around the workpiece.
  • Tighten the safety strap using the ratchet (26).
  • To loosen the safety strap, press the pawl (27) on the ratchet and pull out the safety strap.
  • Attach the safety strap so that the power tool will move away from you if it slips.

  • Do not adjust the height of the drive unit during operation.

The height of the drive unit (10) can be adjusted depending on the length of the application tool and the size of the workpiece.

  • Use the crank handle (4) to adjust the height of the drive unit (10) to correspond to the application tool that is in use.