Starting Operation

  • Pay attention to the mains voltage. The voltage of the power source must match the voltage specified on the rating plate of the power tool.
  • Products that are only sold in AUS and NZ: Use a residual current device (RCD) with a nominal residual current of 30 mA or less.

Reversing the Rotational Direction

  • Only operate the rotational direction switch (4) when the power tool is not in use. Otherwise it may become damaged.

The rotational direction switch (4) is used to change the rotational direction of the power tool. However, this is not possible while the on/off switch (3) is being pressed.

Right rotation: To drill and to drive in screws, press the rotational direction switch (4) through to the left stop.

Left Rotation: To loosen and unscrew screws and nuts, press the rotational direction switch (4) through to the right stop.

Switching On/Off

To start the power tool, press and hold the on/off switch (3).

Press the lock-on button (2) to lock the on/off switch (3) in this position.

To switch off the power tool, release the on/off switch (3).

Adjusting the speed

You can adjust the speed of the power tool when it is on by pressing in the on/off switch (3) to varying extents.

A light pressure on the on/off switch (3) results in a low rotational speed. Increased pressure on the switch causes an increase in speed.